features glass passivated chip junctions ideal for automated placement ultrafast reverse recovery time low profile package high forward surge capability high temperature soldering 260 /10 seconds at terminals component in accordance to rohs 2002/95/1 and weee 2002/96/ec major ratings and characteristics mechanical date case: jedec do-214aa molded plastic body over glass passivated chip terminals: solder plated, solderable per j-std-002b and jesd22-b102d polarity: laser band denotes cathode end 100 a 35 ns v f 0.95 v, 1.25 v, 1.7 v t j max. 150 c i f(av) 3.0 a v rrm 50 v to 600 v i fsm t rr maximum ratings & thermal characteristics (t a = 25 c unless otherwise noted) note 1: mounted on p.c.b. with 0.28 x 0.28? (7.0 x 7.0mm) copper pad areas. electrical characteristics (t a = 25 c unless otherwise noted) note 2: pulse test:300 s pulse width,1% duty cycle. es3d es3e items symbol es3a es3g ES3H es3j unit 100 150 200 300 es3b es3c 400 500 600 v 70 105 140 210 420 v 100 150 200 300 a / w thermal resistance from junction to lead (1) r jl 400 500 600 v a maximum dc blocking voltage items test conditions symbol es3a~d es3e~g ES3H~j unit maximum instantaneous forward voltage i f =3a (2) v f 0.95 1.25 1.70 v maximum reverse current v r =v dc t a =25 i r 5 a t a =100 50 reverse recovery time i f =0.5a i r =1a i rr =0.25a t rr 35 ns typical junction capacitance 4.0 v ,1mhz c j 45 pf 100 maximum repetitive peak reverse voltage v rrm 50 maximum rms voltage v rms 35 v dc 280 350 25 operating junction and storage temperature range t j , t stg ?55 to +150 50 maximum average forward rectified current i f(av) 3 peak forward surge current 8.3 ms single half sine-wave superimposed on rated load i fsm http://www.trr-jx.com es3a-es3j surface mount superfast rectifiers
characteristic curves (t a =25 unless otherwise noted) http://www.trr-jx.com es3a-es3j surface mount superfast rectifiers
package outline notice product is intended for use in general electronics applications. product should be worked less than the ratings; if exceeded, may cause permanent damage. or introduce latent failure mechanisms. the absolute maximum ratings are rated values and must not be exceeded during operation. the following are the general derating methods you design a circuit with a device. i f(av) : we recommend that the worst case current be no greater than 80% . i fsm : this rating specifies the non-repetitive peak current. this is only applied for an abnormal operation, which the general during the lifespan of the device. t j : derate this rating when using a device in order to ensure high reliability. we recommend that the device be used at a t j of below 125c. trr is registered trademark of rising-sun technology. rising-sun te chnology reserves the right to make changes to any product i n this specification to improve reli ability,functional characterist ics,or design without notice. rising-sun technology does not assure any liability arising out of the applic ations or any product descr ibed in this specificat ion. rising-sun technology advises customers to obtain the latest vers ion of the device information before placing orders to verify that the required information is current. http://www.trr-jx.com es3a-es3j surface mount superfast rectifiers
|
